Knowledge

Quality Requirements For Work Shoes

Jul 20, 2023 Leave a message

The main heel position is in the back of the leather shoes. Baotou in the front of the leather shoes, they are not deformed leather shoes designed to make, should be installed between the upper and the shoe two layers of material. Use the thumb pressure to press the Baotou is not soft deformation, with the thumb and index finger press the main heel of the next part of 2/3 also not soft deformation, and size, height to-to be qualified.

 

Identify the quality of leather shoes ⑴, uppers (help): Smooth leather shoes are soft, plump, feel comfortable, luster uniform, not loose surface, the velvet surface is short and uniform, luster uniform. ⑵, shoes are part of the upper, used to improve the help surface extension deformation and improve the sense of foot, it should have good tactile, breathable and moisture wicking, not easy to decolorization, should not wrinkle and fat edge. ⑶, insoles: Keep the soles of shoes clean, improve the sense of foot, should have a good moisture wicking, flat adhesion on the bottom, can not wrinkle, dangling. ⑷, outsole: The bonding state around the outsole should be closely bonded, no voids, and the bottom surface is flat. ⑸, Heel: natural straight. ⑹, side check: the outsole (forefoot) and the plane contact point should be in the middle, the shoe tip must have the proper upturned head (2-3mm), the heel is straight in the plane. ⑺, back check: heel upright, after stitching should be upright. ⑻, two pairs of shoes pair: length, height, shape consistent or to the lining, bright color consistent. Source: Labor shoes manufacturers, work shoes manufacturers, safety shoes manufacturers.

 

Natural substrates include natural bottom leather, bamboo, wood, etc., synthetic substrates including rubber, plastics, rubber and plastic materials, recycled leather, elastic cardboard and so on. Table 1 shows the basic physical properties of the main sole material. The stop-slip design of sole, the coarse and rugged soles of sole, can effectively increase the actual contact area, thus increase the friction and improve the effect of skid-stopping. The structure, thickness and depth of different shading are also different from the actual surface contact area. Fine lines, in support of the human body, easy to wear, resulting in a rapid decline in the effect of the smooth, rough shading, on the general road of walking, deformation reduction caused by poor skid effect.

 

The design of shoe soles is more important in the wet-type interface, and the shading design of the drainage system directly affects the effect of the soles in the wet contact surface environment. When there is water between the soles and the contact surface, the sole grain can not effectively exclude water to the bottom groove and the sole side, the water will exist between the soles and the ground, the thin layer plays the role of lubrication, greatly reducing the friction between the soles and the ground, resulting in slippage. Therefore, the soles of the design, both the drying of the contact surface, but also to consider the water moist contact surface. However, the surface of the soles is often used for different purposes, and there are different contact surfaces and different soles of the structure design, table 2 gives some common shading design.

Send Inquiry